Reebok 3500C User Manual download pdf (Page 26)

PROBLEM SOLUTION

a. Make sure that the power cord is plugged into a surge suppressor, and that the

surge suppressor is plugged into a properly grounded outlet (see page 8). Use

only a single-outlet surge suppressor that meets all of the specifications described

on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. Make sure that the key is fully inserted into the console.

c. Check the reset/off circuit breaker located on the

frame near the power cord. If the switch protrudes as

shown, the circuit breaker has tripped. To reset the

circuit breaker, wait for five minutes and then press

the switch back in.

a. Check the circuit breaker located on the treadmill frame near the power cord (see

1. c. above). If the circuit breaker has tripped, wait for five minutes and then press

the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, un-

plug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console and then reinsert it.

d. Make sure that the reset/off circuit breaker is in the on position (see 1. d. above).

e. If the treadmill still will not run, see the front cover of this manual.

a. Use only a single-outlet surge suppressor that meets all of the specifications de-

scribed on page 8.

b. If the walking belt is overtightened, tread-

mill performance may decrease and the

walking belt may be permanently dam-

aged. Remove the key and

UNPLUG THE

POWER CORD. Using the included allen

wrench, turn both rear roller adjustment

bolts counterclockwise 1/4 of a turn.

When the walking belt is properly tight-

ened, you should be able to lift the edges

of the walking belt 7 to 10 cm (3 to 4 in.)

off the walking platform. Be careful to

keep the walking belt centered. Plug in the power cord, insert the key and run the

treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b. If the walking belt still slows when walked on, see the front cover of this manual.

1. The power does not

turn on

2. The power turns off

during use

3. The walking belt

slows when walked

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and

follow the steps listed. If further assistance is needed, see the front cover of this manual.

Rear Roller Adjustment Bolts

7–10 cm

Reset

Tripped

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Reebok 3500C User Manual Page 26

Comments to this Manuals

Related products and manuals for Treadmills Reebok 3500C