Reebok i run se User Manual download pdf (Page 16)

The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking board be

checked periodically for lubrication to ensure optimal treadmill performance. Please ensure the lubrication of the

running belt is checked every 4-6 weeks after the initial 100 miles/kilometers of use.

Every 30 days or 30 hours of operation lift the sides of the walking belt and feel the top surface of the walking

board as far as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the

touch, follow the instructions below. Please use a non-petroleum based silicone.

To apply lubricant to the walking belt:

1. Position the walking belt so that the seam is located on top and in center of the walking board.

2. Insert the spray nozzle into the spray head of the lubricant can if a nozzle is required.

3. While lifting the side of the walking belt, position the spray nozzle between the walking belt and the

board approximately 6" from the front of the treadmill. Apply the silicone spray to the walking board,

moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray

approximately 4 seconds on each side.

4. Allow the silicone to "set" for 1 minute before using the treadmill.

Deck lubrication

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

Reebok i run se User Manual Page 16